More than just power.

TM


AL600ULMR multi-output access control power supply/charger is specifically designed for use with access control systems and accessories. This unit converts a 115VAC, 60Hz input into five (5) individually protected Class 2 Rated power limited 12VDC or 24VDC outputs. Each output will route power to a variety of access control hardware devices including Mag Locks, Electric Strikes, Magnetic Door Holders, etc. These outputs will operate in both Fail-Safe and Fail-Secure modes. Controlled trigger input is achieved through normally open (N.O.) or normally closed (N.C.) supervised input or the polarity reversal from an FACP (Fire Alarm Control Panel). A form "C" dry output relay enables HVAC Shutdown, Elevator Recall or it may be used to trigger auxiliary devices.
  • Input:

  • Input 115VAC, 60Hz, 3.5A.
  • Input fuse rated @ 3.5A./250V.
  • Fire Alarm Panel or Access Control System trigger inputs. N.O. or N.C.supervised trigger input and polarity reversal trigger input.
  • Output:

  • 12VDC or 24VDC selectable outputs.
  • 6A. supply current.
  • Five (5) PTC protected Class 2 Rated power limited outputs, rated @ 2A.
  • Output relay energizes when unit is triggered (form "C" contact rated 1A. @ 28VDC).
  • Filtered and electronically regulated output.
  • Short circuit and thermal overload protection.
  • Battery Backup:

  • Built-in charger for sealed lead acid or gel type batteries.
  • Automatic switch over to stand-by battery when AC fails.
  • Supervision:

  • AC fail supervision (form "C" contacts).
  • - Notification trigger is selectable for 30 seconds (factory set) or 6 hours.
  • Low battery supervision (form "C" contacts).
  • Battery presence supervision (form "C" contacts).
  • Power fail supervision relay (form "C" contacts).
  • Visual Indicators:

  • AC input and DC output LED indicators (power supply board).
  • Red LEDs indicate condition of power outputs (multi-output board).
  • Power & input trigger LEDs (multi-output board).
  • Electrical:

  • Operating temperature: 0° C to 49° C ambient.
  • BTU/Hr.:
  • - 12VDC: 36.85BTU/Hr.
  • - 24VDC: 73.7BTU/Hr.
  • System AC input VA requirement: 402.5VA.
  • Lifetime Warranty
  • MEA - NYC Department of Buildings Approved
  • Enclosure:

  • Wall mount enclosure for indoor use.
  • Accommodates up to two (2) 12VDC/7AH batteries.
  • Dimensions 13.5"H x 13"W x 3.25"D (343mm H x 330mm W x 83mm D)
  • 1/2" and 3/4" combination knockouts.
  • Weights (approximate):

  • Product Weight: 7.9 Lbs (3.583 kg)
  • Shipping Weight: 8.9 Lbs (4.036 kg)
 

Your message has been sent!

Compare ...

 

Products Similar to

Other